![bescor mp-101 motorized pan tilt head problems repair bescor mp-101 motorized pan tilt head problems repair](https://i.ytimg.com/vi/CggOXqequxQ/hqdefault.jpg)
![bescor mp-101 motorized pan tilt head problems repair bescor mp-101 motorized pan tilt head problems repair](https://static.bhphoto.com/images/fb/1223151.jpg)
To make the mount pan to the right you first need to setup the IO’s. Included in this kit is a Bescor MP-101 motorized head which will pan/tilt cameras weighing up to 6 pounds, an AC adapter to provide power to the MP-101 head, and a 20' extension cable for the remote control included with the MP-101 head. Extend the remote length via optional 20 and 50 foot extension Cable. The MP101 can support up to a 6 pound camera. powered by 4 1.5-volt 'AA' batteries with optional ac adaptor available. I used pins B5, B6, F7 and F6 as denoted on the board.įrom here you can control the pan and tilt by using the teensy’s arduino compatible com port. With the Becsor MP-1E Kit you can remotely control your camera's pan/tilt from across the room. Bescor MP-101 - Motorized tripod head Review. You need to connect the power from the H-Bridge to the Teensy so it can opperate and you need to connect the PWM wires to four of the data IO’s. The Teensy will control the whole project. This head can be powered by four AA batteries (not included) It includes a Bescor PS-260 AC Power Supply for MP-101 Motorized Pan Head and a Bescor RE-20 extension affords 20 (609.6cm) of additional separation from the MP-101 remote pan head to its remote control. You can attach the power directly from the batteries to this allowing for you to power the teensy from the H-Bridge as well as powering the motors.Īt this point you can add a switch to turn it on and off when you want.Ĥ, 5, 13, 12 ground Step 3: Attach the Teensy When you have the six wires you need from the pan and tilt camera mount you need to attach them to the H-Bridge in the attached format.
![bescor mp-101 motorized pan tilt head problems repair bescor mp-101 motorized pan tilt head problems repair](https://i.ebayimg.com/images/g/eLYAAOSwwO9ftc50/s-l300.jpg)
For this you need some soldering experience and a bit of patience.Ĥ33 mhz transmitter and receiver :- On Off switch Step 2: Solder The H-Bridge